Installation Manual 10 Document #: LTRT-59809
MediaPack Series
2.1 Installing the MP-11x Series
This subsection describes the MP-11x hardware installation.
2.1.1 Physical Description
The subsections below provide a physical description of the front and rear panels of the
MP-11x.
2.1.1.1 MP-11x Front Panel
The device's front panel provides LEDs for indicating various operating statuses. The figure
below displays the front panel of the MP-118. This is similar to the MP-114 and MP-112
models, differing only in the number of Channel Status LEDs (corresponding to the
number of channels). For a description of the device's LEDs, refer to 'Monitoring Front-
Panel LEDs' on page 49.
Figure 2-1:
MP-11x (e.g., MP-118) Front Panel
2.1.1.2 MP-11x Rear Panel
The device's rear panel provides the ports for cabling the device to the various interfaces.
The figure below illustrates the rear panel of the MP-118 device, as an example.
Figure 2-2: MP-11x (e.g., MP-118) Rear Panel Connectors
To Next Page
Loading...
