Rialto 600/Bijou 600 Addendum
Two bold new features have been added to the Rialto 600 and Bijou 600: Default Volume Bypass and IR Learning!
Both of these new features are accessed using the RTR-1 remote control that came with your unit.
Default Volume Bypass Procedure
1. Turn on the Rialto 600 or Bijou 600, and point the RTR-1 remote at the unit.
2. Enter the following number sequence using the remote 1, 2, and 3 buttons:
2 3 1 2 2 3 3
While entering this sequence, please keep a slow steady pace that matches
the front input LEDs, making sure they switch correctly with each press.
3. Once the code has been entered, the input LEDs will ash 2 times to indicate
that the default volume setting has been bypassed.
4. To turn the default volume feature back on, enter the same sequence again.
Once the code has been entered, the input LEDs will ash 4 times to indicate
the default volume is engaged.
5. If you want to check if the volume is bypassed or not, enter the sequence:
1 1 2 2 3 1 1
The input LEDs will ash: 2 ashes means that the default volume setting is bypassed, 4 ashes means the default volume is engaged.
IR Learning Procedure
The new IR Learning feature allows the Rialto/Bijou 600 to learn commands from your favorite remote control, such as volume up/down and
source selection.
1. Turn on the Rialto 600 or Bijou 600, and point the RTR-1 remote at the unit.
2. Enter the following number sequence using the remote 1, 2, and 3 buttons: 3 1 2 1 3 2 3
While entering this sequence, please keep a slow steady pace that matches the front input LEDs, making sure they switch
correctly with each button press.
continued..
Code Description
2 3 1 2 2 3 3
Change Default
Volume Status
1 1 2 2 3 1 1
Check Default
Volume Status
3 1 2 1 3 2 3
Enter or Leave IR
Learning Mode
1
To Next Page
Need help?
General
