audioengine A5+ setup guide
7
The Audioengine 5+ speakers have ampliers built into the left cabinet
and the included speaker wire is used to connect both speakers to
each other. The A5+ uses high quality, ve-way gold plated binding
posts that will accept heavy gauge bare wire, banana plugs, spade
lugs, or pin terminators.
Step 2 - Connecting the Speaker Wire
o
p
1) Use your thumb and nger to unscrew the
binding post connectors on the back of each
speaker.
2) Insert each speaker wire into the holes on the
side of binding post connectors, making sure to
connect the positive (+) terminal on the left
speaker to the positive (+) terminal on the right
speaker.
3) Retighten the binding posts with your ngers.
4) Verify that only the exposed portion of the
speaker wire is secured rmly in each connector.
5) Make sure that none of the speaker wire strands
have come in contact with an adjoining terminal.
Note:
As the Audioengine 5+ speaker system includes built-in power ampli-
ers, do not connect the speaker terminals to the speaker outputs of a
stereo receiver or amplier.
115
A5+ Back Left
A5+ Back Right
To Next Page
Loading...
Need help?
General
Weight and Dimensions
