1) Plug the AC plug into a wall outlet that has AC 110-240V~60/50 Hz.
2) Press the POWER button to turn on the DVD player.
1) Press the OPEN/CLOSE button to open the disc tray. Place a disc into the disc tray with the label facing up.
* For a double sided disc, load the side which you wish to play facing down.
2) Press the OPEN/CLOSE button to close the disc tray. The playback will start once the disc loads.
* Some discs may not playback automatically. You can press the PLAY/PAUSE button to start playback.
1) Press the STOP button once to go to pre-stop mode. Some discs the DVD player will recall the stopped location.
2) Press the PLAY/PAUSE button to resume playback from the location where playback was stopped.
2) Each press of the NEXT or PREVIOUS button during playback will skip back or forward through the chapters.
*PREVIOUS and NEXT functions are not available in chapter repeat and A-B repeat mode.
2) Press the PLAY/PAUSE button to resume normal playback.
NOTE:
1) FAST REVERSE and FAST FORWARD functions are not available in A-B repeat mode.
3) Press the STOP button twice to stop completely. This will cause the disc to go back to the beginning. Press the
PLAY/PAUSE button to begin playback from the start of the disc.
1) During disc playback, press the PREVIOUS button to go back to the start of the previous chapter, or the NEXT
button to skip to the start of the next chapter.
1) During playback, you can press the FAST REVERSE or FAST FORWARD to either fast forward or reverse
through the disc. Each time either of these buttons are pressed, the fast forward/fast reverse speed will change.
There are 5 levels of speed available: x2, x4, x8, x16, x32.
2) DVD Discs that do not match the region code cannot be played on this player. You can find the DVD region on
the back of the DVD case or on the actual DVD. Australia and New Zealand are classified as Region 4.
POWER ON THE PLAYER
LOADING A DISC
STOP PLAYBACK
PREVIOUS AND NEXT
FAST FORWARD AND FAST REVERSE
1) During disc playback, press the SLOW button to enter slow forward mode. There are 4 speeds available: 1/2, 1/4,
1/8, 1/16.
2) Press the PLAY/PAUSE button to resume normal playback.
While playing the disc, press the TITLE button to go to the title menu. (May not be available on all discs).
1) Press the VOLUME +/- buttons on the remote control to adjust the volume.
2) Press the MUTE button on the remote control to switch the sound off. The MUTE icon will show up on the TV
screen. Press the mute button again to turn mute off. Alternatively, you can also press the VOLUME +/- buttons to
cancel mute and restore sound.
SLOW
TITLE
VOLUME ADJUSTMENT
1) During playback, press the STEP button to play the DVD frame by frame.
2) Press the PLAY/PAUSE button to resume normal playback.
"Title Remain".
During playback, press the OSD button on the remote control to set "Chapter Elapsed", "Chapter Remain", "Title
Elapsed",
STEP
OSD
(On Screen Display)
→
2x
→
3x
→
4x
During the playback of DVD's, press the ZOOM button to enlarge the image by the following order:
ZOOM
To resume normal viewing, press the ZOOM button again until the picture returns to its normal state.
OPERATIONS--DVD PLAYBACK
10
To Next Page
Loading...
