AMP 310
Applications:
• Ideal for use as a remote amplifier
• Single or Dual Zone Amplifier
• Amplify MP3 Players (With Authority!)
• Rear Channel Amplifier for Dolby 6.1 and 7.1 Systems
• Excellent Stand-Alone Stereo Amplifier
Key Features:
• Massive Flexible Power!
• 2 Independent channels rated at 150 watts into 8 ohms
• Line 1/ Line 2 Priority input switching
• Line 2 Auxiliary output
• Front panel diagnostic LEDs
• Front panel balance and volume trim controls
• Independent rear left/right master level controls
• Signal sensing “Power On”
• Bridgeable
• 12VDC “Trigger On”
• Speaker A/B switching
• High level inputs
• Triple-Darlington Power Amplifier Stages
• Dual-differential error amplifiers
• Rack-mount ready
Specifications
• Power: 150 watts RMS @ 8 ohms
• 225 watts @ 4 ohms
• 450 watts @ 8 ohms bridged
• Less than 0.1% THD into 8 ohms
• Input Sensitivity 350mV to 2.8Vrms
• S/N Ratio: 100 dB A-weighted
• Frequency response: 20Hz to 50kHz
To Next Page
