EasyManua.ls Logo

Audison LR 435 - Characteristics; Precautions; Installation; Warning

Audison LR 435
18 pages
To Next Page IconTo Next Page
To Next Page IconTo Next Page
To Previous Page IconTo Previous Page
To Previous Page IconTo Previous Page
Loading...
ENGLISH
CHARACTERISTICS
LR 435, LR 435 XR: Four-channels amplifiers, compact in size with high level musical qualities.
The fundamental features of the sophisticated circuitry are; front end stage made with two
differential complementary stages, final stages consisting of a pure complementary symetric
inverted triplet, final transistors with in current capacity equal to 15A, and high energy reserve
PWM power supply with MOSFET.
LR 435: Four channels, single or double input, 4, 3, and 2 channels function.
LR 435 XR: Four channels, single or double input, electronic crossover with linear adjustement
which can also be excluded, HI-PASS / BY-PASS output, 4, 3, and 2 channels function
(crossover off) or 2 channels for HI-PASS and SUB stereo / mono (crossover on).
PRECAUTIONS
·In order for this device to function properly it's important that it be installed in a spot where the
temperature doesn't fall below 0°C (32°F) or rise above 55°C (131°F).
· It must be installed in a dry and well ventilated spot.
· The power supply voltage is 12 Vcc negative to ground. Make sure that the caracteristics of the
vehicle's electrical system are compatible.
· For safe driving it's advised to listen to music at volume level that won't drown out external traffic
noise
INTALLATION
For mounting use 4 self-threading screws and protective plastic rings provided. For a very good
result we suggest to use audison cable products to complete your installation. These include:
power cables, signal cables, speaker wires RCA connectors and all accessories needed to
complete the wiring.
WARNING
· INPUT: If the radio-cassette player's output GND isn't connected to car body, the braided shield
of shielded cable must be connected to the radio-cassette player's chassis.
· OUTPUTS: Never connect the output to ground or each other. If a crossover filters is used sure
the two channels don't have a common ground.
· REGULATION: If you should hear distortion phenomena at moderate volume levels it means
a distorted signal is coming from the radio-cassette player. Turn radio-cassette player volume
down unit there's no longer any distortion.
Then adjust amplifier levels unit just beginning to hear slight distortion phenomena.
3
LR 435 XR (CROSSOVER ON)
ONE INPUT / SUB MONO
LR 435 XR - (CROSSOVER ON)
WIDEBAND FRONT AND REAR WITH OR WITHOUT FADER
34

Related product manuals