AUMA Aumatic AC 01.1 Operation Instructions

2
Actuator controls AUMATIC AC 01.1 / ACExC 01.1
Profibus DP Operation instructions
Scope of these instructions: These instructions are valid for multi-turn actuators of the type ranges
SA(R) 07.1 – SA(R) 16.1 and SA(R)ExC 07.1 – SA(R)ExC 16.1
as well as for part-turn actuators of the type ranges
SG 05.1 – SG 12.1 and SGExC 05.1 – SGExC 12.1
with the controls AUMATIC AC 01.1 or ACExC 01.1
with Profibus DP interface.
Table of contents Page
1. Safety instructions 4
1.1 Range of application 4
1.2 Commissioning (electrical connection) 4
1.3 Maintenance 4
1.4 Warnings and notes 4
2. Short description 4
3. Transport and storage 5
4. General information about Profibus DP 5
4.1 Basic characteristics 5
4.2 Basic functions of Profibus DP 6
4.3 Transfer mode 6
4.4 Bus access 6
4.5 Communication 6
4.6 Functionality 6
4.7 Protection functions 6
4.8 Device types 6
5. Technical data 7
6. Design AUMATIC Profibus DP 11
7. Electrical connection 12
7.1 Power supply (standard) 12
7.2 Remote position transmitter 12
7.3 AUMATIC on wall bracket 12
7.4 Fitting of the connection housing 13
7.5 Test run 13
7.5.1 Bus connection (standard) 13
7.5.2 Mains and bus connection for explosion-proof version 15
7.5.3 Bus cables 17
7.6 Setting the Profibus DP address via local controls 18
8. Commissioning with controls 20
8.1 Introduction 20
8.2 Programming 20
8.3 Configuration of the Profibus DP interface of the AUMATIC 20
8.4 Communication start-up 21
8.5 Description of AUMA user parameters 21
9. Process representation input 25
9.1 Process representation input arrangement 1 (default process representation) 25
9.2 Description of the process representation input arrangement 1 (default process representation) 26
9.3 Process representation input arrangement 2 34
9.4 Process representation input arrangement 3 35
9.5 Process representation input arrangement 4 36
10. Process representation output 37
10.1 Description of the output data 37
11. Operation parameters of the AUMATIC 40
11.1 Profibus DP V1 services 40
11.2 Integration into the process control system 40

AUMA Aumatic AC 01.1 Specifications

General

Brand	AUMA
Model	Aumatic AC 01.1
Category	Control Unit
Language	English