Need help?Do you have a question about the AUMA AMExC 01.1 and is the answer not in the manual?
General| Brand | AUMA |
|---|---|
| Model | AMExC 01.1 |
| Category | Control Unit |
| Language | English |
Details important safety precautions, warnings, and notes for safe operation.
Describes how to send OPEN, CLOSE, and SETPOINT commands via Modbus.
Provides a flowchart to diagnose and resolve issues where the actuator is unresponsive to Modbus.
Details the connection board, switch positions for termination, and cable assignment.
Details electrical connection for explosion-proof versions with plug/socket connectors.
Describes electrical connection for explosion-proof versions with plug-in terminal connections.
Details how to set the baud rate, parity, and stop bits on the Modbus interface board.
Explains how to set communication parameters like default mode, address, and baud rate.
Details the procedure for selecting and setting the Modbus baud rate using push buttons and LEDs.
Provides a step-by-step guide to setting the Modbus slave address using push buttons.
Lists Modbus functions (e.g., Read Holding Register) and their associated offset addresses.
Explains how to read actuator signals (logical, actuator, fault) using Modbus register functions.
Provides detailed descriptions of input data bits for logical signals, actuator signals, and fault signals.
Explains how to send commands (OPEN, CLOSE, SETPOINT) and read status using register functions.
Guides on checking and setting DIP switches on the logic board for actuator behavior.
To Next Page
