AUMA SQEx 10.2 - Page 3

295.4.2. Parking frame
306. Operation................................................................................................................................
306.1. Manual operation
306.1.1. Manual operation: engage
306.1.2. Manual operation: disengage
306.2. Motor operation
306.2.1. Local actuator operation
316.2.2. Actuator operation from remote
326.3. Menu navigation via push buttons (for settings and indications)
336.3.1. Menu layout and navigation
346.4. User level, password
346.4.1. Password entry
356.4.2. Password change
356.5. Language in the display
356.5.1. Language change
377. Indications..............................................................................................................................
377.1. Indications during commissioning
377.2. Indications in the display
387.2.1. Feedback indications from actuator and valve
407.2.2. Status indications according to AUMA classification
417.2.3. Status indications according to NAMUR recommendation
437.3. Indication lights of local controls
437.4. Mechanical position indication (self-adjusting)
447.5. Mechanical position indication via indicator mark
458. Signals (output signals).........................................................................................................
458.1. Status signals via output contacts (digital outputs)
458.1.1. Assignment of outputs
458.1.2. Coding the outputs
458.2. Analogue signals (analogue outputs)
469. Commissioning (basic settings)...........................................................................................
469.1. End stops in part-turn actuator
479.1.1. End stop CLOSED: set
479.1.2. End stop OPEN: set
489.2. Type of seating: set
499.3. Torque switching: set
519.4. Limit switching: set
529.5. Fieldbus address (slave address), baud rate, parity and monitoring time: set
539.5.1. Modbus TCP/IP gateway: set
539.6. Test run
539.6.1. Direction of rotation at mechanical position indicator: check
549.6.2. Limit switching: check
5510. Commissioning (settings in the actuator)...........................................................................
5610.1. Switch compartment: open/close
5610.2. Mechanical position indicator (self-adjusting)
5710.2.1. Mechanical position indicator: set
5710.2.2. Gear stage of the reduction gearing: test/set
5810.3. Mechanical position indication via indicator mark (not self-adjusting)
5910.3.1. Mechanical position indicator: set
3
SQEx 05.2 – SQEx 14.2 / SQREx 05.2 – SQREx 14.2 Control unit: electronic (MWG)
ACExC 01.2 Non-Intrusive Modbus TCP/IP Table of contents