auna multimedia iTuner CD - DAB; Station List

59
EN
DAB
Press the MODE button repeatedly or press the FM/DAB button on the
remote control to select “DAB radio”. The unit will enter DAB mode and
perform the auto scan function. During the scan the display will show
“Scanning… ” together with a slide bar that indicates the progress of the
scan and the amount of stations that have been found so far. (F.7) Once
the scan has nished, the unit will select the rst alpha numerically found
station. To explore the found stations, press the PRESET ∧/∨ buttons to
select and press the SELECT button to conrm.
Station List
1. During DAB mode, press the MENU button to access DAB menu.
2. Press the PRESET
∧/∨ buttons to select “Station List” and then press the
SELECT button to conrm.
3. A list of DAB+ stations will show on the display.
Auto Scan
1. Press the MENU button, and then press the / buttons to select Scan.
Press the SELECT button to conrm.
2. The display will show “Scanning…” and a progress slide bar.
3. All the stations that have been found will be stored automatically. To
explore and listen to the found stations, press the PRESET
∧/∨ buttons
to select and the press the SELECT button to conrm.
Manual Tuning
As well as the auto tune function, you can manually tune the receiver. This
can help you when aligning your aerial or when adding stations that were
missed while auto tuning.
1. Press MENU on the remote control to display the menu.
2. Press the PRESET
∧/∨ buttons to select “Manual tune”, and press the
SELECT button to conrm.
3. The display will show the multiplex 5A to 13F.
4. Press the PRESET ∧/∨ buttons to select the channel, and press the
SELECT button to conrm.
DAB Display Modes
Every time you press the INFO button on the remote control or press and
hold the INFO button on the unit, the display will show the following display
modes: DLS – Programme Type – Ensemble/Frequency – Signal error/
Strength – Bit rate/Codec/Channels – Date
DAB
radio
DAB Radi o
Scan
Stations: 0
Scanning