auna multimedia iTuner CD - FM Operation; Auto Scan

61
EN
FM OPERATION
Switching from DAB to FM Mode
To switch the unit to FM mode, press the MODE button repeatedly to switch
to FM mode. The display will show the frequency.
Auto Scan
Press and hold the TUNINGbuttons to start searching for a station..
The search may not stop at a station with a very week signal..
Manual Tuning
To search for FM stations manually, press the TUNING buttons repeatedly
until your desired frequency is reached.
With FM radio, it may be necessary to ne tune each station by pressing the
TUNINGbuttons repeatedly. Each press will adjust the frequency by 0.05
MHz. If reception is still poor, adjust the position of the aerial or try moving
the radio to another location.
Scan Setting
1. Press the MENU button to access FM menu.
2. Press the PRESET
∧/∨ buttons to select Scan setting and then press the
SELECT button to conrm.
3. Press the PRESET ∧/∨ buttons to select Yes to receive Strong stations
only and then press the SELECT button to conrm.
Audio Setting
Press the MONO/ST. button on the remote control to toggle between the
Stereo or Mono selection.
Alternatively
1. Press the MENU button to access the main menu.
2. Press the PRESET
∧/∨ buttons to select Audio setting and press the
SELECT button to conrm.
3. Press the PRESET ∧/∨ buttons to select YES to listen in Mono only or
NO to let the unit select Stereo or Mono automatically.
4. Press the SELECT button to conrm.
FM
radio
FM Radi o