auna C500 - Safety Instructions; Technical Data

22
EN
TECHNICAL DATA
Item number 10032117 10032118 100321119
Outputs 2 channels 4 channels 6 channels
Max. Output power 1000 W 2000 W 3000 W
High pass 50 Hz - 500 Hz
Low pass 50 Hz - 250 Hz
Signal-to-noise ratio 90 dB
Frequency response 10 Hz - 30 kHz
Input sensitivity 120 mV - 1.0 V
Impedance Signal-to-noise ratio
Load impedance 2 - 8 Ω
Attenuation factor > 120
Bass boost (50 Hz) 0/+6/+12 dB
Power supply 10.5 - 15 V
Dimensions (mm) 200 x 250 x 52 200 x 280 x 52 350 x 250 x 52
SAFETY INSTRUCTIONS
Power supply
• Do not connect the +12 V power cable until all other cables are
connected.
• Make sure that the unit's earth wire is securely connected to a metal
point on the vehicle.
• If you are using the car radio without the remote output to the amplier,
connect the remote input terminal (REM OTE) to the power supply
accessory.
• Use the power cable with an attached fuse (40 A).
• Ensure that the cables to the +12 connection and earth connection have
a larger cross-section than 5 mm2.