auna C500 - Functions

32
EN
Assembly
Place the box where you want to mount it and mark the four drill holes on
the mounting board (not included). Drill holes with a diameter of approx. 3
mm. Screw the device on with the enclosed screws (15 mm). Make sure that
the board is at least 15 mm thick.
Note: Tighten the screws rmly but do not use too much force. The
torque should be less than 1 Nm.
FUNCTIONS
1
Operating display
Lights up green during operation.
2
Protection control lamp
Overvoltage: lights up red in case of overvoltage or short circuit
Oset: lights up when the voltage to the speaker terminals is too
high.
Thermal: lights up when the temperature is too high.
3
Filter selector switch
When the switch is set to LPF, the lter is set to low pass. When
the switch is set to HPF, the lter is set to high-pass.