auna C500 - Connections

24
EN
CONNECTIONS
Before connecting, note the following
• Before connecting, take the earth o the car battery to avoid short
circuits.
• Make sure that the speakers have the appropriate power. If you connect
speakers with insuicient power rating, they may be damaged.
• Do not connect the "- clamps" of the speakers to the body of the car
and also connect the "- clamp" of the right speaker to that of the left
speaker.
• Place the input and output cables away from the power supply lead,
otherwise interference will occur.
• This device is a powerful amplier. Therefore, it cannot reach its full
potential when operated with the pre-installed cables of the car
speakers.
• If your car is equipped with a computer/navigation system, do not
disconnect the ground from the car battery as this could erase the
computer memory. To avoid short circuits when making connections,
disconnect the lead for the 12 V power connection until all other
connections have been made.
Replacing the fuse
• If the fuse is blown, check the power connections and insert a new fuse.
If the fuse blows again after replacement, there may be an internal
malfunction. In this case, contact a workshop.
• The new fuse must match the amplier and correspond to the
specications on the fuse holder. Never use a fuse with a current rating
that exceeds the specications of the appliance fuse, otherwise the
appliance could be damaged.