GB6
3.5 Fitting the mattress
Put your bed in the horizontal position.
Put the mattress on the mesh base
and centre it.
Make sure that the five protruding clip-
on pins of the anchors are pushed
widthways into the mesh (see fig. 5).
‘Click’ the anchors into the mesh at the
positions indicated (see fig. 6).
Make sure that the anchors are not
directly above a cross bar.
3.6 Preparing for use
Check that the mesh base can move
freely. Only adjust the mesh base while
it is in a horizontal position, securely
fixed to the supporting legs, or to the
supports provided within the bed
surround.
Check that the mattress is attached to
the mesh base properly.
Insert the plug into the wall socket.
The plug has a safety cut-out.
Attention
The cable clips can be used to prevent
an untidy tangle of leads under the
bed. Attach these clips to the under-
side of the stationary part of the
frame. Make sure that the cables
never become jammed between the
moving parts. Place the cable clips at
least 25 mm from the moving parts.
3.7 Tips for use
A new mattress has a certain amount
of rigidity, which will disappear within a
few days. Consequently, your
mattress will not optimally follow the
contours of the mesh base when it is
initially adjusted. We therefore recom-
mend that you lie down on the
mattress while adjusting the positions
for the first time.
fig. 5
fig. 6
To Next Page
Loading...