Aura Allure - Assembling Spray Gun Components; Air Filter Maintenance and Replacement; Proper Unit Storage Guidelines

11
EN
Aura Allure with Xena Click & Tan
Assembly
1) Slide the nozzle seal (Fig. 12, 1) with the
groove (slot) facing forwards into the
nozzle (Fig. 12, 2).
2) Put the nozzle onto the gun body and nd
the correct position by turning it.
3) Put the air cap onto the nozzle and tighten
it using the union nut.
4) Place the container seal (Fig. 13, 1) from
below on the feed tube (Fig. 13, 2) and
slide it over the collar, while turning the
container seal slightly.
5) Insert the feed tube with container seal
in the gun body.
15. Maintenance
Important! NEVER operate the system
without the air lter tted;
dirt could be sucked in and
interfere with the function of
the system.
1) Wash the air lter if it is soiled (check
daily in the case of intensive/commercial
use and replace if heavily soiled).
2) For this pull the air lter out of the unit
(Fig. 14).
3) Insert a clean air lter.
16. Storage
Store unit away in a safe place with cord
wrapped around unit without any twisting.
1
2
12
13
1
2
14