9
EN
Aura Allure with Xena Click & Tan
12. Tips on using the spray tanning system
Before commencing application, check that all necessary protective
measures (nasal plugs, safety goggles, hair covering) have been taken.
i
Practice on a large piece of cardboard or paper rst of all in order to nd the
optimal settings for the spray tanning lotion used.
•
The spray movement should come
from the arm, not just from the wrist.
This ensures that a uniform distance is
maintained between the spray gun and
the body during the spray operation.
Select a distance of 10 - 20 cm, depending
on the desired spray jet width.
Fig. 8 a: CORRECT Even distance
Fig. 8 b: INCORRECT uneven distance
will result in uneven tanning
•
Move the spray gun at an even speed
•
When tanning is complete, switch o ,
turbine and any tanning extraction fan (if
used) after fumes/mist have cleared.
a
b
8
13. After application of the spray tanning lotion
i
The full tanning e ect develops during the rst 6-12 hours after the treatment.
•
Allow the spray tanning lotion to dry for 10-15 minutes
before getting dressed again. It is advisable to wear very
loose clothing to prevent the fresh tanning lotion rubbing
off the body.
i
You can also use the warm air from the Click & Tan
dryer to accelerate the drying process if the spray
tanning lotion feels moist on the skin (Fig. 9).
To do this follow the instructions in section 11
"Disconnect and reconnect the Handle from the
Gun Body".
•
DO NOT shower or bathe in the first 6-8 hours after
application as this will affect the tanning result.
9
To Next Page
Loading...