Aura Allure - System Start-up and Operation; System Start-up Procedures; Operating the Spray Tanning System; Spraying Technique and Pattern Adjustment

7
EN
Aura Allure with Xena Click & Tan
10. Start-up
Before connecting to the mains supply, be
sure that the supply voltage is identical with
the value given on the rating plate.
1. Unscrew the container from the spray gun.
2. Prepare spray tanning lotion according to
manufacturer's instructions and pour into
the container.
3. Screw the container tightly onto the spray
gun.
4. Mount the air hose (Fig. 2, a + b).
5. Place the device only on a horizontal level
clean surface. Otherwise, the gun may suck
in dust, etc.
6. Remove hand jewellery to avoid scratching
the gloss surfaces of the spray gun.
DO NOT FILL ABOVE MAX LEVEL INDICATED
ON SIDE OF POT, OVERFILLING MAY CAUSE
POSSIBLE LEAKING
11. Operation
How the Spray Tanning system is handled,
including preparation of the work place
and spray tanning lotion as well as the
nal result, is the sole responsibility of
the operator.
Wagner excludes any liability for damage
which may arise from overspray, applica-
tion errors, touch-ups, or non-compliance
with the instructions provided here.
•
Turn ON/OFF dial on the device (Fig.3).
•
Turn the material control (Fig. 4, 1) in
order to adjust the desired delivery rate.
+ and - symbols are marked on the dial.
lower material volume (-):
 turn anticlockwise
higher material volume (+):
 turn clockwise
4
1
5
1
2
a
b
c
6
Fig. 6a vertical at spray pattern: For spray movements from left to right
Fig. 6b horizontal at spray pattern: For spray movements from top to bottom
Fig. 6c round contouring jet: For a small round pattern for contouring and
shading. Turn the volume down (Fig4, 1) for a smaller pattern.
•
Pull the trigger to spray the tanning lotion.
•
Turn the air cap (Fig. 5, 1) with the union
nut slightly unscrewed (2) to adjust the
shape of the spray spray pattern: