Aura Allure - Preparation for Spray Tanning; Spray Area Setup; Pre-Application Preparations; Skin Preparation for Tanning

6
EN
Aura Allure with Xena Click & Tan
7. Preparation of the spray area
•
Remove all objects from the spray area if possible in order to avoid contamination
from overspray.
•
Work in a room with a smooth, easy-to-clean surface.
The use of a spray tent and extraction fan is recommended.
•
Place the motor unit as far away from the spraying area as possible to prevent the
lter clogging up with tanning mist.
•
Never place the motor unit inside the tent.
8. General preparations before the application of spray
tanning lotion
i
Test the compatibility of the spray tanning lotion on a small patch of skin
approx. 24 hours before the actual application of the spray tanning lotion.
Stop application if skin irritations occur.
•
Approx. 24-48 hours prior to treatment remove body hair by shaving or waxing.
•
DO NOT apply any perfume, deodorant or make-up. These products can negatively
inuence the tanning result.
•
On the day of the treatment wear dark, loose-tting clothing in order to prevent
discoloration of clothing by the spray tanning lotion.
•
Remove all jewellery in order to avoid discoloration by the spray tanning lotion.
3
9. Preparation of the skin
i
Correct preparation of the skin is the key to an even and long lasting tanning
result. Please note the following instructions:
•
Remove all dead skin cells by means of
exfoliation before applying the spray
tanning lotion.
•
Make sure that the moisture content of
the skin is as uniform as possible.
Use a moisturizer for dry areas (e.g.
elbows and knees). Let the moisturizer
dry before commencing the treatment.
•
Apply a little balm to lips, nails, palms of
the hands, eyebrows and the hairline for
protection.
b
2
a