Aura Allure - Troubleshooting and Malfunction Correction; Troubleshooting: No Lotion or Dripping; Troubleshooting: Spray Quality Issues; Troubleshooting: Overspray and Uneven Tan

13
EN
Aura Allure with Xena Click & Tan
18. Correction of Malfunctions
Malfunction Cause Remedy
No spray tanning
lotion comes out of
the nozzle
•
Nozzle clogged
•
Material volume setting
turned too far to the left (-)
•
No pressure build-up in
container
•
Container empty
•
Feed tube loose
•
Feed tube clogged
•
Clean
•
Turn material volume
adjusting screw to the right
(+)
•
Tighten container
•
Rell
•
Insert
•
Clean
Spray tanning
lotion drips out of
the nozzle
•
Spray tanning lotion has
accumulated on the air cap,
nozzle or needle
•
Nozzle loose
•
Nozzle seal worn
•
Nozzle worn
•
Clean
•
Union nut tighten
•
Change
•
Change
Atomization too
coarse
•
Material volume adjusting
screw turned too far to the
right (+)
•
Nozzle contaminated
•
Too little pressure build-up in
container
•
Air lter heavily soiled
•
Union nut is loose
•
Turn material volume
adjusting screw to the left
(-)
•
Clean
•
Tighten container
•
Replace
•
Make sure that the union
nut is fully tightened
Uneven spray
pattern
•
Spray tanning lotion in the
container is running out
•
Nozzle seal worn
•
Air lter heavily soiled
•
Rell
•
Replace
•
Replace
Excessive overspray
•
Distance too large
•
Material volume adjusting
screw turned too far to the
right (+)
•
Reduce distance
•
Turn material volume
adjusting screw to the left
(-)
Spray tanning
lotion runs down
body
•
Too much spray tanning
lotion applied
•
Spray paths overlap too much
•
Spraying distance too small or
spray movement too slow
•
Carefully dab aected
points with a towel, reduce
ow setting if required and
lightly overspray again
The tan is patchy or
blotchy
•
Skin was not correctly
prepared
•
Spray movement not even
enough
•
Correct by lightly
overspraying