14
EN
Aura Allure with Xena Click & Tan
Malfunction Cause Remedy
Customer's skin
appears orange
•
Too much spray tanning
lotion applied
•
Skin was not correctly
prepared
•
High sensitivity to active
ingredient DHA
•
Remove spray tanning
lotion from the skin
•
Prepare skin correctly for
new application, reduce
ow setting
•
Use another shade with
lower concentration of DHA
The tanning
solution is bubbling
from the container
•
Seal is not inserted properly
•
Solution container is not
screwed on correctly
•
The container is mis-threaded
•
Solution container is overlled
•
Make sure the seal is
pressed down, so all air is
removed from behind the
seal
•
Standing the gun on a at
surface screw the container
onto the gun. This will help
you to keep the container
straight
•
Standing the gun on a at
surface screw the container
onto the gun. This will help
you to keep the container
straight
•
Pour some solution away.
Only ll to the maximum
measurement mark on the
side of the container
The air ow is
cutting in and out
•
The lter is soiled too heavily
•
Remove the lter from the
base of the unit and rinse
through with warm water.
When the water runs clear,
the lter is clean. Dry lter
before re-tting
The spray gun is
leaking from the
cup
•
The solution container is not
tight enough
•
There is too much solution in
the container
•
Tighten container so the
measurements fall in line
with the nozzle at the front
of the gun
•
Pour some solution away.
Only ll to the maximum
measurement mark on the
side of the container
To Next Page