16
EN
Aura Allure with Xena Click & Tan
Malfunction Cause Remedy
The gun is blowing
air but spraying no
solution
•
Very little or no solution in
solution container
•
Blocked nozzle
•
Solution container is not
tightly screwed onto the gun
•
Union nut is too tight causing
restriction on the needle
movement
•
Add solution
•
Remove the 3 part nozzle,
clean and re-assemble
•
Tighten solution container
•
Loosen union night very
slightly. Too loose and
you will cause too much
solution to exit the gun
Technical Data
Power source: 220-240V 50-60Hz
Power consumption: 280 W
Double insulation:
Sound pressure level: 75.5 dB (A)
Air hose length: 3.5m
Container capacity: 150 ml
Weight: approx. 1.6 kg
Important Note regarding Product Liability!
Due to an EC ordinance in eect since 01.01.1990, the manufacturer is liable for this
product only if all parts originate from or were approved by the manufacturer and the
devices are assembled and operated correctly. The use of other accessories and spare
parts can partially or completely invalidate the liability.
Environmental protection
The appliance and accessories should be recycled in an environmentally
friendly way. Do not dispose of the appliance with household waste. Support
environmental protection by taking the appliance to a local collection point or
obtain information from a specialist retailer.
To Next Page
Loading...