Aura Allure - Operational Safety Precautions; Electrical Safety and Maintenance Precautions

4
EN
Aura Allure with Xena Click & Tan
•
NEVER leave spray tanning system unattended.
•
Stay alert and watch what you are doing.
•
DO NOT operate the unit when fatigued or under the inuence of drugs or alcohol.
•
Follow all appropriate local, state, and national codes governing ventilation, re
prevention, and operation.
•
NEVER direct the spray gun at animals.
•
Ensure that the spray area is well ventilated.
•
DO NOT breathe in spray tanning solution. Wearing nasal plugs and operating an
extraction fan designed for the purpose is recommended.
•
DO NOT spray into the eyes.
•
If spray tanning solution is sprayed into the eyes, wash eyes out with water immediately
and consult a doctor.
•
DO NOT spray tanning solution into open wounds or onto damaged skin.
•
Cover your hair when spraying your face. Otherwise bleached hair in particular could be
stained by the spray tanning solution.
•
NEVER immerse the Spray Tanning System into water.
•
WARNING! NEVER use your Spray Tanning System near bath tubs, shower trays
or other receptacles that contain water.
•
NEVER place the Spray Tanning System near a washbasin or another water source. Water
always represents a hazard even when the system is switched o.
•
NEVER expose the equipment to rain.
•
DO NOT use outdoors or operate where aerosol (spray) products are being used.
•
NEVER drop or insert any object into any opening or hose.
•
NEVER block air openings of the spray turbine.
•
Keep electrical cord plug and spray gun trigger free from liquids.
•
NEVER hold the cord at plug connections to support the cord. Failure to observe may
result in an electrical shock.
•
Keep cord away from heated surfaces.
•
NEVER operate spray tanning system if cord or plug is damaged.
•
As additional protection, the installation of a residual current protective device (RCD) with
a rated tripping current of no more than 30mA is recommended in the bathroom circuit.
Ask your installer for advice.
•
DO NOT use a 3 to 2 adapter.
•
Unplug turbine before cleaning any parts.
•
Use only manufacturer authorized parts. User assumes all risks and liabilities when using
parts that do not meet the minimum specications and safety devices of the turbine
manufacturer.
•
NEVER open the Spray Tanning System yourself to carry out electrical repairs!
•
DO NOT place the spray gun on its side, as material could leak out.