AUSA CH 200 - Forklift Securing Procedures; Securing the Forklift

26
CH 200 / CH 250
Safety
(fig. 18)
(fig. 17)
(fig. 16)
·
Always drive with the forks in the low position and with the mast tilted slightly back.
·
Make certain that long or wide loads are fastened together so as to be stable and secure.

When leaving the forklift (fig.16-17)
·
Place the forks in the fully lowered position.
·
Set all the controls in the “O” neutral position.
·
Apply the parking brake.
·
Do not park the forklift on a slope.
·
Stop the engine and cut the ignition circuit. Remove the ignition key.
·
Lock all mechanisms to prevent any unauthorized person from using the machine.