Page | 14
4. Switch LPG Water Heater ON using the rocker switch located at the bottom on the LPG
Portable Water Heater. Do this by having the red dot pushed in.
5. Ensure that the button on the shower rose is in the “Off” position.
6. Open the valve for your input water source. This can come from your 12v pump or mains
supply. When ready push the button “On” your shower rose. Water should start to flow
through the shower unit.
7. Note: You should hear a series of clicks and then the burner should ignite. The burner flame
can be seen operating through the ‘viewing window’ located at the front of the appliance.
8. Adjust the temperature of the water flowing from the showerhead by turning the ‘gas
regulator’ and ‘water regulator’ knobs.
Note: For higher temperatures, increase the gas regulator control and decrease the water regulator
control. Switching the BURNER control from LOW to HIGH will increase the temperature further.
A temperature in excess of 50° C will activate the Over Temperature Safety Sensor and will
shut down the burners. To relight the burners, you will need to turn the water flow OFF and then
back ON.
To Next Page
Loading...