AUSTRALIAN MONITOR IS SERIES - Binding Post Outputs; Speaker Outputs

PAGE 7
BINDING POST OUTPUTS
When terminating to the 4 mm binding post (banana jack) output
connectors, banana plugs or bare wires can be used. The red terminal
is positive and the black terminal is negative (ground).
SPEAKER OUTPUTS
When using the 4 pole speaker connector for speaker output, use only
the mating 4 pole in-line connector. This connector is designed so that
both speakers can be fed from a single connector. Two speaker
connectors are provided on the amplifier. The "Channel A" speaker
connector actually carries both channel A & Channel B outputs (see:
Speaker Connector Wiring Diagrams). The "Channel B" speaker
connector carries the Channel B output only. This arrangement allows
you the option of connecting to the outputs separately or together.
Connecting through a single connector has the advantage of
minimising connections, preserving phasing and simplifying channel
allocation, which is particularly important when bi-amping.
IMPORTANT
Do not overload your amplifier by connecting the channel B
output twice!
Channel A is used as the "dominant" channel and when sourcing
a dual output from Channel A, the following standard should be used:
Channel A = Left or Low Frequencies.
Channel B = Right or High Frequencies.
INSTALLATION
IS SERIES INSTALLATION & OPERATION MANUAL