EasyManuals Logo

AUTEC Dynamic ARX User Manual

Default Icon
12 pages
To Next Page IconTo Next Page
To Next Page IconTo Next Page
To Previous Page IconTo Previous Page
To Previous Page IconTo Previous Page
Page #11 background imageLoading...
Page #11 background image
Signals Possible reason Solutions
The STATUS LED blinks
slowly.
Over-voltage on power
supply.
Make sure that the receiving unit power
supply is within the voltage limits
provided in the technical data.
The STATUS LED blinks
fast and irregularly.
The receiving unit loses
some data sent by the
transmitting unit.
Bring the transmitting unit close to the
receiving unit.
If this signal persists, contact the support
service of the machine manufacturer.
The STATUS LED is on.
Over-current in one of the
PWM analogue outputs.
Contact the support service of the
machine manufacturer.
The SETUP LED blinks
once.
Error on the address key.
Contact the support service of the
machine manufacturer.
The SETUP LED blinks
twice.
Error on the memory
board.
Contact the support service of the
machine manufacturer.
The SETUP LED blinks
quickly.
Two or more analogue
commands are being
activated simultaneously
within the REMOTE
SETUP procedure.
Check actuators on the transmitting
unit and activate one single analogue
command.
AUTEC - Dynamic Series
Malfunction signalled by the receiving unit 11
LIARXE00-00

Questions and Answers:

Question and Answer IconNeed help?

Do you have a question about the AUTEC Dynamic ARX and is the answer not in the manual?

AUTEC Dynamic ARX Specifications

General IconGeneral
BrandAUTEC
ModelDynamic ARX
CategoryReceiver
LanguageEnglish

Related product manuals