6.4 Restoring factory settings
This procedure is used to restore factory settings for the proportional outputs.
1. Ensure that the transmitting unit is switched o.
2. Power on the receiving unit.
3. Press the TEACH pushbutton in the receiving unit and do not release it until the SETUP
LED illuminates.
4. Press the TEACH pushbutton three times and do not release it at last pressure; the SETUP
LED blinks fast: this indicates that factory settings are being restored.
5. Release the TEACH pushbutton when the SETUP LED is steadily illuminated again. If
the TEACH pushbutton is released before the SETUP LED is steadily illuminated, factory
settings of proportional outputs will not be restored.
6. To leave the procedure, press the TEACH pushbutton on the receiving unit and do not
release it until the SETUP LED switches o.
AUTEC - Dynamic Series
Values of proportional outputs 9
LIARXE00-00