AUTEC MBC930D - Product Presentation

2 Brief product presentation
2.1 Battery and Battery Charger
The object of this part of the Manual is the MBM06MH battery, that is meant to be used inside
an Autec Radio Remote Control's Transmitting Unit, and the related MBC825A (80-250V ),
MBC825A (110V ) and MBC930D battery chargers, that are needed to recharge it.
2.2 Conformity with standards
2.2.1 Conformity of MBC825A (80-250V ) Battery Charger
The MBC825A (80-250V ) battery charger complies with the EMC Directive
(2014/30/EU), the LVD Directive (2014/35/EU) and with the following
harmonised standards: EN 55014-1, EN 55014-2, EN 61000-3-2, EN 61000-
3-3, EN 62233, EN 60335-1, EN 60335-2-29.
2.2.2 Conformity of MBC825A (110V ) battery charger
The MBC825A (110V ) battery charger complies with the EMC Directive
(2014/30/EU), the LVD Directive (2014/35/EU) and with the following
harmonised standards: EN 55014-1, EN 55014-2, EN 61000-3-2, EN 61000-
3-3, EN 62233, EN 60335-1, EN 60335-2-29.
This device complies with part 15 of the FCC Rules.
Operation is subject to the following two conditions:
(1) this device may not cause harmful interference, and
(2) this device must accept any interference received, including interference
that may cause undesired operation.
2.2.3 Conformity of MBC930D battery charger
The MBC930D battery charger complies with the EMC Directive (2014/30/
EU) and with the following harmonised standards: EN 55014-1, EN 55014-2.
The MBC930D battery charger complies with Directive 72/245/EEC as last
amended by Directive 2006/96/EC (e24 mark) and the approval number is
e24*72/245*2006/28*1639*00.
This device complies with part 15 of the FCC Rules.
Operation is subject to the following two conditions:
(1) this device may not cause harmful interference, and
(2) this device must accept any interference received, including interference
that may cause undesired operation.
AUTEC -
Brief product presentation 11
LIUMBS001_eng-02