AUTEC MBC930D - MBC930 D Battery Charger; MBC930 D Technical Specifications

5 MBC930D battery charger
The MBC930D battery charger is used to charge the MBM06MH rechargeable battery used
in Autec Radio Remote Controls.
A
B
C
D
E
A Power supply cable
B Contacts
C CHARGE LED
D POWER LED
E Technical data plate
5.1 Technical data
Power supply voltage ......................................................................................... 9 - 30V
Power consumption ...................................................................................................... 7W
Output voltage ............................................................................................................... 9V
Output current ........................................................................................................ 450mA
Power supply protection fuse ................................................................................ T250mA
Max. recharge time ................................................................................ see paragraph 3.1
Recharge temperature ........................................................................... see paragraph 3.1
Protection degree
....................................................................................................... IP40
Dimensions ................................................................ 100x134x57mm (3.94x5.27x2.24In)
5.2 Plates
Technical, identi󰘰cation and approval data of the MBC930D battery charger are provided in
the plate on the front of the device, where the signalling LEDs are. You may also 󰘰nd another
plate with approval data in the battery housing.
These plates must not be:
- removed from their position (removal voids the guarantee)
- altered or damaged (contact Autec for replacement)
AUTEC -
MBC930D battery charger 25
LIUMBS001_eng-02