4.3 Electrical connection
Never use the battery charger if it is damaged.
Check that the Battery Charger power supply voltage is within the limits
given in the “Technical data”.
Place the battery charger in a position that allows to easily reach and remove
the supply cable.
It is good practice to connect the battery charger to the AC mains socket only
when recharging the battery. Once the charging has been completed, disconnect
the battery charger from the AC mains socket.
4.4 Positioning
Place the Battery Charger in an indoor and dry place, far from liquids, dust
and heat sources.
Leave at least 5cm (1.97In) room above and around the Battery Charger.
Do not set any objects on the battery charger when it is connected to the
AC mains socket.
Do not in any case perforate, modify or tamper with the Battery Charger.
AUTEC -
MBC825A (80-250V) and MBC825A (110V) battery chargers 19
LIUMBS001_eng-02
To Next Page
Loading...
