AUTEC MBC930D - Page 32

Signals Possible reason Solutions
When the battery is
inserted, the CHARGE
LED blinks for more than
one hour.
Check if the malfunction occurs
with both the batteries provided:
if the same result is obtained with
both, it may be assumed that
the Battery Charger is damaged;
otherwise the damage concerns
one of the two batteries.
Replace the Battery Charger or
the battery.
When the battery is
inserted and 󰘱at, the
CHARGE LED is o󰘯.
Dirty contacts on the battery and/
or on the Battery Charger.
Clean the contacts on the battery
and on the Battery Charger with
a non-abrasive cloth or brush
and a generic electrical contact
cleaner. Then charge the battery.
Check if the malfunction occurs
with both the batteries provided:
if the same result is obtained with
both, it may be assumed that
the Battery Charger is damaged;
otherwise the damage concerns
one of the two batteries.
Replace the Battery Charger or
the battery.
Battery run time is
signi󰘰cantly shorter than
normal.
Dirty contacts on the battery and/
or on the transmitting unit.
Clean the contacts on the battery
and on the transmitting unit with
a non-abrasive cloth or brush
and a generic electrical contact
cleaner. Then charge the battery.
Check if the malfunction occurs
with both the batteries provided:
if the same result is obtained with
both, it may be assumed that
the Battery Charger is damaged;
otherwise the damage concerns
one of the two batteries.
Replace the Battery Charger or
the battery.
If the problem persists after attempting the suggested solution, contact the support service
of the Machine Manufacturer.
32
LIUMBS001_eng-02
Malfunctions
AUTEC -