10
5. Do not use unauthorized chargers. The voltage and current output by unauthorized chargers
cannot fully match the battery cells, which may cause damage to the batteries.
6. Avoid leaving the charger plugged in for a long time as this may damage the charger.
Battery Maintenance Conditions
In order to keep the aircraft battery healthy, maintenance is recommended if any of the following
conditions are met:
1. The battery has been cycled 50 times.
2. The battery has been inactive for 3 months.
3. The App prompts users that the battery needs maintenance.
Battery Inspection Process
1. The battery performs a standard charge and discharge operation.
2. Insert the battery into the aircraft and power on, check the battery information through the
app, check whether the voltage difference between the battery cells is less than 0.1V, and whether
the battery firmware is up to date.
3. Check whether the battery is bulged, leaked, or damaged.
4. Check the battery connector for dirt, damage or rust.
Charging And Discharging a Battery
Use the original charger, or the maintenance charging mode of the charging box, charge to 100%
and let it stand for 24 hours. Then discharge to below 20% and let it stand for 1 hour.
1. Charge the battery to 100% and let it sit for 24 hours.
2. Insert the battery into the aircraft to fly, when the battery is less than 20%, land the aircraft.
After landing, remove the battery.
3. Let the battery stand for 1 hour.
4. After completing the battery maintenance process, it can be charged and stored.
Battery Replacement Standards
1. There are obvious bulges, leakage, and damage on the battery surface.
2. Replacement is recommended after 300 cycles.
3. After 2 consecutive standard charging and discharging operations, if the abnormality of the
battery still cannot be recovered, it is recommended to replace it.
Battery Disposal
1. Use an insulated bucket filled with 5% salt water and fully submerge in it for more than 48
hours until fully discharged.
2. After step 1, refer to the "Battery Safe Operation Guidelines" for correct recycling procedures
to avoid any environmental pollution.
Precautions
1. Keep away from flammable and explosive items during charging.
To Next Page
Loading...
