140
NOTE
1. All required work must be carried out before the service indicators are
reset. Failure to do so may result in incorrect service values and cause
DTCs to be stored by the relevant control module.
2. For some vehicles, the scan tool can perform added functionality to reset
additional service lights (maintenance cycle, service interval). Taking
BMW as an example, its service reset function includes engine oil, spark
plugs, front/rear brakes, coolant, particle filter, brake fluid, micro filter,
vehicle inspection, exhaust emission inspection and vehicle check.
All software screens shown in this manual are examples, actual test screens
may vary for each vehicle being tested. Observe the menu titles and on-
screen instructions to make correct option selections.
To perform oil reset functions
1. Tap the Service application button from the MaxiIM Job Menu.
2. Tap Oil Reset button and wait for the vehicle manufacturer screen.
You can tap VIN Scan or the vehicle make to acquire vehicle VIN
information and tap Yes to confirm. See Vehicle Identification on
page 94 for detail.
3. Tap the function you want in the Oil Reset function list, the list may
vary for different vehicles being tested.
Figure 7-1 Sample Oil Reset Function List
To Next Page
Loading...
