Autel MaxiTPMS TS201 - Magnet Scan; Help

12
4.3 Magnet Scan
Sometimes a magnet is needed when the original sensor is triggered. The
TS201 offers the third method “Magnet Scan” to activate the sensor.
To activate the sensor, put the magnet onto the valve stem and hold the
TS201 no more than 2 inches from the tire sidewall.
Figure 4.11
From Auto Scan screen, use the UP or DOWN Arrow button to select
Magnet Scan, and press the OK button. For the detail operation process,
please reference the “Scan By MMY” section on Page 14.
4.4 Help
This function allows the user to view the explanation about the three methods
for further understanding.
From Auto Scan screen, use the UP or DOWN Arrow button to select
Help, and press the OK button. Wait for the Help screen to display.