Autel OTOFIX D1 Pro User Manual

i
Trademarks
OTOFIX is a trademark of Autel Intelligent Technology Corp., Ltd., registered in China,
the United States, and other countries. All other marks are trademarks or registered
trademarks of their respective holders.
Copyright Information
No part of this manual may be reproduced, stored in a retrieval system or transmitted in
any form or by any means electronic, mechanical, photocopying, recording, or otherwise
without the prior written permission of Autel Intelligent Technology Corp., Ltd.
Disclaimer of Warranties and Limitation of Liabilities
All information, specifications and illustrations in this manual are based on the latest
information available at the time of printing.
Autel Intelligent Technology Corp., Ltd. reserves the right to make changes at any time
without notice. While information of this manual has been carefully checked for accuracy,
no guarantee is given for the completeness and correctness of the contents, including
but not limited to the product specifications, functions, and illustrations.
Autel Intelligent Technology Corp., Ltd. will not be liable for any direct, special, incidental,
or indirect damages, or for any economic consequential damages (including lost profits)
as a result of using the product.
IMPORTANT
Before operating or maintaining this unit, please read this manual carefully, paying extra
attention to the safety warnings and precautions.
For Services and Support
www.otofixtech.com
1-855-288-3587/1-855-AUTELUS (North America)
0086-755-86147779 (China)
support@otofixtech.com
For technical assistance in all other markets, please contact your local OTOFIX
distributor.

Autel OTOFIX D1 Pro Specifications

General

Brand	Autel
Model	OTOFIX D1 Pro
Category	Diagnostic Equipment
Language	English

Summary

Getting Started

Powering Up

Instructions on how to turn on the diagnostics tablet and boot the system.

Powering Down

Procedures for safely shutting down the diagnostics tablet.

Rebooting System

Diagnostics

Establishing Vehicle Communication

Guide to connecting the tablet and VCI device to a vehicle for diagnostics.

Getting Started

Vehicle Identification

Explains methods for identifying the vehicle for diagnostic purposes.

Main Menu

Service

Access to specialized vehicle service and maintenance functions.

Generic OBDII Operations

Exiting Diagnostics

Steps to properly exit the diagnostics application and disconnect.

Service

Oil Reset

How to perform the Engine Oil Life system reset procedure.

Electric Parking Brake (EPB)

Instructions for maintaining the electronic parking brake system.

Tire Pressure Monitoring System (TPMS)

Battery Management System (BMS)

Immobilizer (IMMO) Keys

Steering Angle Sensor (SAS)

Procedures for calibrating the steering angle sensor for accurate readings.

Remote Expert

Device Connection

Remote Expert Orders

Battery Test

OTOFIX BT1 Lite Tester

Introduction to the BT1 Lite tool for battery and electrical system analysis.

Test Preparation

In-vehicle Test

Performing battery, starter, and generator tests on an installed vehicle battery.

Out-vehicle Test

Testing battery health status when it is not connected to a vehicle.

Software Updates

VCI Manager

Remote Desktop

Operations

MaxiViewer

MaxiVideo

Operations

MaxiScope

Maintenance and Service

Maintenance Instructions

Guidelines for cleaning and maintaining the diagnostic tablet and VCI unit.

Troubleshooting Checklist

Common issues and solutions for tablet operation and charging problems.

About Battery Usage

Important information and precautions regarding the tablet's built-in battery.

Service Procedures

Information on technical support, repair services, and optional parts.

Warranty

12-month Limited Warranty