Page 3 (20)
Introduction
About this manual
This manual has been published primarily for professionals and qualified
personnel. A person using this material is assumed to have basic
knowledge in marine systems, and be able to carry out related electrical
work.
Work on the boats low-tension circuit should only be carried out by
qualified and experienced persons. Installation or work on the shore
power equipment must only be carried out by electricians authorised to
work with such installations.
It is the sole responsibility of the installer to ensure that the installation
work is carried out in a satisfactorily manner, that it is operationally in
good order, that the approved material and accessories are used and that
the installation meet all applicable rules and regulations.
Note: Auto-Maskin continuously upgrades its products and reserves the
right to make changes and improvements without prior notice.
All information in this manual is based upon information at the time of
printing.
For updated information, please contact your dealer or Auto-Maskin
directly.
Assumptions
This document describes the DCU 305 R3. The unit can be used in
Auxiliary or Propulsion installations.
The unit will be referred to as the Control Unit.
When referring to voltages, always assume DC-voltages. When referring
to AC-voltages it will be mentioned explicit.
About the DCU 305 R3 & R3 LT
The DCU 305 R3 is an electronic control unit for control and monitoring
of diesel engines used as propulsion engines or gensets.
Switches and senders from the engines are connected to the control unit
on the wire terminal card RK-66.
Each project is unique, which is why the DCU 305 R3 is customised
using a configuration tool for Windows®, the Rudolf R3 software.
To Next Page
Loading...
Need help?
General
