What to do if the Auto Mate ValveLink 8.2 ValveLink8.2 LEDs are not lighting up when plugged in?
First, check the power connections and disconnect all valves to check for a short. Keep in mind that the ValveLink8.2 valve LEDs will not light if valves are not plugged in. Also, the ValveLink8.2 uses an internal "poly" fuse which resets itself after an overload. Try unplugging the ValveLink8.2 for a while, then reconnect it.
Describes solution switching for physiological research.
Offers faster switching and precise delivery.
Using front-panel pushbuttons to toggle valves.
Controlling valves via TTL signals from external hardware.
Displays valve status and detects faults.
Monitors for leaks and closes all valves.
Controls valves using binary TTL inputs.
Extends addressing to 16 valves with two units.
Ensures only one valve is open at any given time.
Warnings about product use and environment.
Conditions requiring unplugging and service.
General| Number of Channels | 8 |
|---|---|
| Communication Protocol | HART |
| Power Supply | 24 VDC |
| Housing Material | Aluminum |
| Protection Class | IP66 |
To Next Page