23
IT EN FR DE ESIT EN FR DE ES
5.3 - ERRORS
In case of a problem, the device shuts down and the display will show one error message from the following list.
Message Description Troubleshooting
E1
Battery power
(The battery-saver has activated. Power decreased below the
set threshold.)
Start the vehicle in order to recharge the battery.
E2
Power overload from the cooling fan
(The cooling fan overloads the board beyond the allowed
limit. Possible cause: short circuit or something is blocking the
fan from rotating.)
Take the device to an authorised dealer.
E3
Blocked compressor
(The rotor is blocked or the pressure in the cooling circuit is
too high.)
The presence of E3 – E4 – E5 codes do not indicate a
malfunction, but is a normal management procedure for the
compressor by the electronic board. Only if the code continues to
be displayed contact an authorized dealer.
E4
Overcurrent on the compressor
E5
High temperature in the control board
(If the cooling circuit is overloaded or if the surrounding
temperature is too high, the control board signals this issue.)
E6
Empty circuit
(The system may have lost gas.)
Take the device to an authorized dealer.
E7
Temperature probe
(If the probe has short circuited or has become disconnected,
the device stops working.)
E9
Power overload from the condenser fan
(The cooling fan overloads the board beyond the allowed
limit. Possible cause: short circuit or something is blocking the
fan from rotating.)
E0
Disconnected compressor
A power supply cable of the compressor has disconnected.
To Next Page
Loading...
Need help?
General
