ENGLISH
37/78
The following are the menus which can be modified:
P0
- Timer (MIN e AUTO mode)
In MIN and AUTO mode, the system’s default setting is 6 hours of
continuous operation. The default value can be changed in this menu.
The choice range is between 1 and 99 hours.
P1
- Timer (MAX mode)
In MAX mode, the system’s default setting is 4 hours of continuous
operation. The default value can be changed in this menu. The choice
range is between 1 and 99 hours.
A2
- Celsius and Fahrenheit degrees
The system’s default setting is Celsius degrees. This menu allows you
to change the parameter to Fahrenheit degrees.
A3
- Offset
This refers to the temperature difference detected by the probe and the
temperature shown on the display. This menu allows you to change this
value from -9°C to +9°C with 1°C increments.
A4
- Max condenser fan speed
The condenser fan’s speed is variable and depends on the operation of
the compressor. Its default setting is 100% of its operational power. Its
maximum speed can be reduced (for example if it is too loud) according
to the following table. Bold values are its default settings.
WARNING: if the selected speed value is too low, the compressor
may overheat and the device may shut itself down (see error table –
code
E3 – E4 – E5
).
Level Percentage
10 100%
9 90%
8 80%
7 70%
6 60%
5 50%
4 40%
A5
- Battery saver value
Its default setting is 21.5 Vdc (Cut-out) and 24 Vdc (Cut-in). This menu
allows to change the values according to the following table. Default
values are in bold.
24Vdc
24Vdc
Vm
Cut-out Cut-in
Vm
Cut-out Cut-in
0 20 10 20
1 20.3 11 20.3
2 20.6 12 20.6
3 20.9 13 20.9
4 21.2 14 21.2
5 21.5
15 21.5
6 21.8 16 21.8
7 22.1 17 22.1
8 22.4 18 22.4
9 22.7
24
19 22.7
24
To Next Page
Loading...