AutoDAB Connect User Guide
18
where Frequency is the chosen frequency.
3. Press and hold a PX button (where X is from 1 to 4) to save the current selected
FM frequency into the corresponding preset memory FX.
4. The screen will display a short message of 《 FX SAVED》.
Note:
The default FM frequencies saved in presets F1 to F4 are 87.6MHz, 92.5MHz,
102.5MHz and 107.9MHz, respectively.
It is suggested to set those FM frequencies saved in AutoDAB Connect into
FM preset locations of your car radio. Selecting the FM preset of your car
radio and the matching FM preset of AutoDAB Connect will switch the FM
transmission frequency instantly for a clear reception of the DAB station.
Saving the frequency in memory does not affect the current FM transmitting
frequency; it remains the same as before saving the frequency.
To Recall FM Transmitting Frequency Saved in Memory
You may drive into an area where the FM frequency transmitted by AutoDAB Connect
is used by an FM broadcaster. When this happens, your reception of DAB station will
be getting worse with increasing interference from another FM program. Switch to a
free FM frequency will ensure continuous and clear reception of the DAB station to
which you are currently listening.
1. Press LINK, and the screen will show the current FM Transmitting Frequency.
2. Press a PX button (where X is from 1 to 4) to select a corresponding memory
preset FX and the screen will show the FM frequency saved in memory, make a
note of that frequency number.
3. Press the Rotary Knob or after 10 seconds timeout, the AutoDAB Connect will
set and transmit FM signal at this new frequency and the screen will show 《 TO
Frequency 》 where Frequency is the frequency saved in the preset FX.
4. Press FM preset of your car radio corresponds to the same frequency from step 2
if you have previously saved for DAB reception. Otherwise, tune the car radio to
the same FM frequency.
5. Now you can listen to DAB stations via this new FM Frequency.
To Force Immediate FM Transmitting Frequency Change
This function can be used in either AFC or AutoScan mode to force a FM transmission
frequency change immediately.
In AFC_H or AFC_L Mode
While listening to a DAB station, if you hear static noise or a FM program and before
AFC tunes to a clear frequency you can force an immediate frequency change by:
To Next Page
Loading...