AutoDAB Connect User Guide
22
frequency you can force an immediate frequency change manually, refer to
the procedure outlined in the TROUBLESHOOTING section for detail.
While in AFC mode, if the FM transmitting frequency for AutoDAB Connect
and the car radio listening frequency is out of sync and you wish to reset them,
refer to the procedure outlined in the TROUBLESHOOTING section for
detail.
ATTENTION
The AutoDAB Connect comes with the AFC function. In order to use this function,
your car radio must have AF (alternative frequency) feature, and AF must be
enabled. Please consult your car radio manual or the car dealer for these
requirements before using this function.
While working with the AFC function, the possible factors that could affect its
normal operation are:
1. The FM sensitivity varies among car radios and the sensitivity can affect AFC’s
performance.
2. The algorithm implemented in each car radio’s AF feature varies and this can
affect radio’s FM frequency tuning when triggered by AFC.
If AFC function is unable to function normally, please disable AFC and use
AutoScan mode instead. Refer to the next section To enable AutoScan.
To Enable AutoScan
If your car radio does not have AF feature, then you must not enable AFC. However,
you can use AutoScan to automatically search for unused FM frequency for
transmitting. When this function is activated, the AutoDAB Connect will keep searching
available FM frequencies, and display these frequencies whenever you need. You may
select one of them as the new transmitting frequency and tune your car radio in this
new FM frequency to receive DAB services continuously.
1. In the menu function, rotate the Rotary Knob [◄] [►] until the screen shows
《 LINKMODE 》.
2. Press the Rotary Knob, and then rotate the Rotary Knob [◄] [►] until the
screen shows 《 AUTOSCAN 》.
3. Press the Rotary Knob, the function of AutoScan is now enabled and the
AutoDAB Connect is operating in the AutoScan mode.
To Next Page
Loading...