AutoDab Connect - OPERATION CONTROLS; In-Car Display Messages

AutoDAB Connect User Guide
8
OPERATION CONTROLS
In-Car Audio System LCD Display
The AutoDAB Connect unit is operated by using a remote control. The system messages
from the remote control operation are converted to RDS text and displayed as 8 characters
displayed on your car radio.
Below is a list of AutoDAB Connect system messages displayed on the car radio, while
operating with the remote control:
Messages
Description
DABRADIO
 Displays after AutoDAB Connect is powered on.
station name
 Displays the 8-character short service name of the DAB station.
TUNING
 Indicates tuning a DAB station is in progress.
RESETING
 Indicates performing a DAB reset or factory reset is in progress.
DONE
 Confirms completion for certain system operation, i.e., set a DAB preset
mode.
RETUNING
 Indicates FM transmitting frequency is being retuned to a new frequency.
TO frequency
 Indicates AutoDAB Connect is changing FM transmitting frequency to a new
frequency from a manual setting.
AF frequency
 Indicates AutoDAB Connect is changing FM transmitting frequency to a new
frequency from the AFC function. Other than pressing and holding the BACK
key, any other remote control keys pressed are ignored before the change is
completed.
POWEROFF
 Displays after AutoDAB Connect is turned off (into the standby mode).
RC LOW
 Indicates remote control’s battery is low, battery change is due.