AutoDAB Connect User Guide
7
7. Wait 8 hours, and then adhere the AutoDAB Connect to the mounting location by
joining the 4 half pieces of the tapes together.
8. Alternatively, or in addition, secure the AutoDAB Connect with the supplied screws.
Installation, Dos and Don’ts
As AutoDAB Connect has an internal antenna and FM Transmitter, it is important to avoid
signal interference from excessive cable coiling. Below are the dos and don’ts when you
coil and store excessive antenna cable and power cable.
1. Don’t tangle the antenna and power cables together.
2. Do minimize coiling loops of excessive power cable or antenna cable, and don’t secure
them on or besides the AutoDAB Connect. The coiling loops of excessive power or
antenna cables should start at about 10 cm away from the AutoDAB Connect.
Cable
attaches to
AutoDAB
Connect
To Next Page
Loading...