Lowering
Before lowering the lifting device, make
sure that you removed the car stand
support. Remove the safety pin from the
safety system. If you forget to remove the
safety pin, there is a risk of serious
damage to the lifting device.
When lowering the lifting device, always
follow the symbols on the stickers
located near the gearboxes that indicate
the rotation of the drill.
Always make sure that the drill head
rotates in the desired direction. Lower the
vehicle to a position when the weight of
the vehicle rests on its wheels and the lift
can be easily removed from the side of
the vehicle. Always stop the drill in time
and never continue lowering the lifting
device when you reach the lower position!
Storage
This lift should be stored in position on
gearbox lids or hanging on the wall (see
accessories).
Always lower the vehicle slowly! When the lift reaches the lower position, switch o the
drill immediately! Failure to do so may result in injury or serious damage to the equipment
for which the manufacturer is in no way responsible.
It is forbidden to perform any modication, repair, service or maintenance on the lift.
Safety instructions
Do not exceed the allowed capacity. Only
lift vehicles with unibody construction! Do
not use air or impact tools which harm
the gearings, all tools of this type are
strictly prohibited! Use a manual electric
drill with a minimum torque of 55 Nm at
low rotation speed, always in rst gear.
Use the lifting device on a at and solid
surface that provides sucient support.
Secure the lifting device with a safety pin.
It is forbidden to work under the vehicle
without using a car stand support. Never
drive onto the AUTOLIFT3000. Do not use
the AUTOLIFT3000 if it is damaged in any
way. It is forbidden to perform any
modication, repair, service or
maintenance (including checking or
adding lubricants or opening gearboxes)
on the AUTOLIFT3000. The
AUTOLIFT3000 is made exclusively for
lifting vehicles. Any other use is
prohibited.
24 25
To Next Page
Loading...
