Safety instructions
Product assembly and storage
Using and handling
> Read the user manual carefully before assembling and using the product!
> If you have any doubts about the assembly or using the product, please read the
information on our website www.autoliftproduction.com or contact our customer
service at info@autoliftproduction.com.
> The jack may only be assembled and used by an adult person who has read the user
manual.
> Do not assemble or use a product that shows signs of damage.
> Use protective equipment (safety glasses, safety gloves, safety footwear with
reinforced toe...) when assembling and using the product.
> The recommended temperatures for storage and using the lifting device are from +20°F
to +90°F and from -5°C to +30°C.
> Do not leave the lifting device lying in direct sunlight, the lifting rubber may be
damaged. High temperatures can cause lubricants to leak or heat up metal parts of the
structure. If metal parts of the structure are hot, do not touch them without protective
gloves!
> When lifting a vehicle, always take into account the area you are in, the height of the
ceiling (the longer the vehicle to be lifted, the higher the back of the vehicle will be), the
condition of the body and the construction of the vehicle (e.g. never lift a very short
vehicle as "SMART" to its maximum lift!) and follow the rule that safety always comes
rst!
> Always use a suciently powerful drill. A drill with less power can be destroyed by
using for lifting a vehicle! Only use an electric drill in rst gear and always switch o the
impact/hammer. All impact tools are prohibited as they damage the gearboxes. A drill
with a minimum power of 1050 W/220 V/10 Amp is recommended. Min. torque 487
inch-lb or 40 ft-lb or 55 Nm.
> Neither the manufacturer nor the dealer is in any way responsible for injury or damage
caused by improper use of the product.
> Always secure the lifted vehicle with a car stand support and the safety pin.
> Before lowering the vehicle, always make sure to remove the car stand and the safety
pin and check that nothing or no one is under the vehicle or in the close area.
> Use the rails for uneven surface for lifting vehicles on all soft or uneven surfaces
(asphalt, grass, gravel, paint booth grid, stones, pavement...). We also recommend
using this accessory for lifting on all polished or shiny oors to avoid scratching or
damaging them.
> When using the "the rails for uneven surface" accessory, make sure that the wheels of
the AUTOLift3000 always move in the centre of the rail. If this is not the case, move the
rail by pulling so that the wheel is centred again. Wear protective gloves for these
operations.
> When raising and lowering the lifting device, always ensure that the lower or upper
lifting clearance of the product (minimum and maximum lifting limits) cannot be
exceeded. Always approach the maximum lifting limit marked with red STOP tape
slowly and do not exceed it in any case! Also, always approach the lower lifting level
slowly and stop the drill in time. Not following these instructions may result in
irreversible damage to the product, which is not covered by the warranty!
> When raising, lowering or tilting the vehicle, never touch the running wheels or other
moving parts of the product, and prevent any objects, persons or animals from being in
the working area of the lifting device. Secure the environment so that this situation
cannot change. Also ensure that no persons or animals are in the vehicle.
> Never drive over the lifting device!
> The product must not be used by children in any case!
> Always handle the product carefully (and with consideration of your physical condition)
to avoid injury to the user or the surroundings.
> The AUTOLIFT3000 is intended exclusively for lifting passenger vehicles with uni-body
construction! Never use for lifting other types of vehicles or body-on-frame vehicles.
> Never exceed the maximum load capacity of the lifting device (3000 kg/6614 lbs).
> Never exceed the upper lifting limit - marked with red tape with STOP symbol.
42 43
To Next Page
Loading...
