DPM1 User Manual, 1st Edition
User Manual - DPM1 Series Panel Meters
19
keep this code in a safe place (Do not count on your memory). This personal code makes the
default code useless.
If an incorrect code is entered, the meter will return automatically to the run mode. Total
lockout programming is achieved by changing ALL to Yes. Changing ALL to No will lead to
the selective lockout of the programming variables. Programming each one of the parameters
to 1 will active the lockout, if they are set to 0 programming will be accessible. Though the
programming is locked out, it remains possible to visualise the current programming.
The “Stor” indication informs that the modifications effectuated have been stored correctly.
inP
..
..
..
..
.
Enter secret code to access this routine (default code is 0000).
If secret code is forgotten, proceed to load default configuration
to have again acces to parameters lock-out configuration.
Previous settings will be lost.
Allows to change secret code
selecting 'YES'
Total lock-out of parameters
Menu partial lock-out.
0= unlocked
1= locked-out
DISPLAY menu lock-out
SETPOINT1 menu lock-out
SETPOINT2 menu lock-out
SETPOINT1 value menu lock-out
SETPOINT2 value menu lock-out
Serial output menu lock-out
.
Analog output menu lock-out.
(only appears if ANAP is installed. Only
in this case serial output menu does
not appear).
TARE key lock-out
Run Mode
>3s
ENTER
:
Enters configuration and
validates data and parameters.
UP: Increases value of blinking digit in configuration
mode.
SHIFT: Selects mode or shifts blinking digit in
configuration.
(Bottom View)
To Next Page
Loading...
Need help?
General