AutomationDirect DURAPULSE GS3-4030 - Page 80

Chapter 4: AC Drive Parameters
4–12
Communications Parameters
P9.00
Communication Address 01 to 254 01
P9.01
Transmission Speed
00: 4800 baud
01: 9600 baud
02: 19200 baud
03: 38400 baud
01
P9.02
Communication Protocol
00: MODBUS ASCII mode
7 data bits, no parity, 2 stop bits
01: MODBUS ASCII mode
7 data bits, even parity, 1 stop bit
02: MODBUS ASCII mode
7 data bits, odd parity, 1 stop bit
03: MODBUS RTU mode
8 data bits, no parity, 2 stop bits
04: MODBUS RTU mode
8 data bits, even parity, 1 stop bit
05: MODBUS RTU mode
8 data bits, odd parity, 1 stop bit
00
P9.03
Transmission Fault
Treatment
00: Display fault and continue operating
01: Display fault and RAMP to stop
02: Display fault and COAST to stop
03: No fault displayed and continue operating
00
P9.04
Time Out Detection
00: Disable
01: Enable
00
P9.05
Time Out Duration 0.1 to 60.0 seconds 0.5
 P9.07
Parameter Lock
00: All parameters can be set and read
01: All parameters are read-only
00
P9.08
Restore to Default 99: Restores all parameters to factory defaults 00
* Some parameters and settings are available only in later firmware versions of DURAPULSE drives. Refer to
the beginning of this “DURA
PULSE Parameter Summary” section for more information.
 Parameter can be set during RUN Mode.
Parameter Summary (continued)
Parameter
*
Description Range*
Default
Setting
User
Setting
Display Parameters
 P8.00
User Defined Display
Function
00: Output Frequency (Hz)
01: Motor Speed (rpm)
02: Scaled Frequency
03: Output Current (A)
04: Motor Load (%)
05: Output Voltage (V)
06: DC Bus Voltage (V)
07: PID Setpoint
08: PID Feedback (PV)
09: Frequency Setpoint
00
 P8.01
Frequency Scale Factor 0.01 to 160.0 1.0
 P8.02
Backlight Timer
00: Timer Enable (1 min light off)
01:Timer Disable
00
DURAPULSE AC Drive User Manual
1st Ed. Rev. D 05/2013