Page 2–4 SureServo2 User Manual – 1st Edition – 05/20/2021
Chapter 2: Installation
Monitoring DI/DO Codes ParametersAlarms Wiring
In order to have adequate air flow for ventilation, please follow the suggested clearances
when installing one or more servo drives (refer to the following diagrams). Avoid mounting
one servo drive above one another. Keep the bottom of the servo drive clear because the
generated heat rises and causes higher temperature for the drives mounted above.
Note: The diagrams below are not to scale. Please refer to the annotations on the diagrams.
Single Servo Drive Multiple Servo Drives
SV2A-2040 Natural cooling
SV2A-2075, 2150, 2200, 2300
Natural cooling and
forced cooling
* Due to the assembly tolerance, the minimum clearance for the servo drive is 1mm.
To Next Page
Loading...
