AUTOMATOR INTERNATIONAL SRL – Via Meucci n.8–20094 Corsico (Mi) Italia
Tel 02 48601445 Fax 02 48601503 e-mail info@automator.com www.automator.com
Tel 02 48601445 Fax 02 48601503 e-mail info@automator. Com www.automator.com
Tel 02 48601445 Fax 02 48601503 e-mail info@automator. Com www.automator.com
4 MARKING
Before marking, verify that :
➢ The unit has been strongly and correctly fixed to a support
➢ That the collect nut has been strongly screwed
➢ The object to be marked has been positioned on an appropriate support
➢ That the pneumatic connections fit the machine requirements
➢ That the marking head (numbering head or type-holder) has been correctly mounted
The buyer declares that in case the pneumatic marking machine <…….> is used without
security, he has to complete it with adequate protections according to the CE following laws
89/395 and in particular CEE 89/392 CEE 91/368 art. 1 CEE93/44 art. 1 CEE 93/68 art. 6
The integrator must be prepared to complete the apparatus/unit with fit system of personal safety. That is,
it will be the manufacturer of such system to adjust the line itself to the normative CEE.
The Automator International Srl does prohibition of putting the pneumatic unit in service, if it has not been
completed with adequate safety system from the user.
Once performed successfully the adjustments (see Section 3.4. ), follow the steps for the first marking adjustment:
1. Position the part to be marked on the support
The support has to keep the marking head perpendicular to the piece to be marked
Automator assumes no responsibility for the use of a marking head that is not original delivery
Automator
2. Give the Start command
3. When the marking head touches the surface to be marked, the meachanism loads and marks
To Next Page
Loading...